Carrot Patch Money Holder

I am always looking for fun and unique ways to give the gift of money, especially when the recipient is a young person. Since this gift will be for a 2-year old, I knew that it would be destroyed as soon as she put her hands on it. Because of the outcome, I knew that I wouldn't be spending enormous amounts of time and energy on it. At the same time, I wanted it to be cute and something that I felt good giving away.


I designed the Carrot Patch Money Holder to fit a single, tightly rolled U.S. dollar bill. I know that there are templates for carrot boxes out there but I didn't want to search for one and then have to manipulate the pattern to fit my needs. The rule that I set for myself was that it had to be super simple to make without using an actual pattern.

I found that an 8-1/2-inch salad plate was the perfect template needed for this project. Trace the template onto patterned cardstock and cut out the circle.

Cut the circle into 4 equal pie-shaped pieces. Each circle will make 4 carrots.


Make a 1/4-inch cut into the pointed end of the triangle. Trim 1/4-inch off of one side of the triangle (just eyeball it). You should get what resembles a lopsided fan.


Take the side that has been trimmed and bring it over to the opposite end, leaving a 1/4-inch margin. Crease the fold sharply. (The margin will eventually become a tab which will be used to close the box.)


Fold over again and crease the fold sharply.


Trim the pointed end of the tab at a slant.


Form a crease in the 1/4-inch margin to create a tab which will eventually be used to hold the carrot together in a cone shape.


Mark 1-inch from the top of the triangle on both sides.


Trim both sides of the triangle using the 1-inch marking as a guide. (Again, just eyeball it.)


Fold the top down using the 1-inch mark on either side as a guide. Crease well and unfold the entire triangle.


Add glue to the right side of the tab and glue the tab to the inside of the box.


Add a tightly rolled up dollar bill tied with ribbon to the inside of the money holder. Glue or tape the flaps closed.


To create the carrot leaves:

You will need a 1-3/4-inch by 1-3/4-inch piece of cardstock and a 3/8-inch by 8-1/2-inch strip of paper. Run the square piece of paper through a paper crimper if you desire.


Cut thin strips into the 1-3/4-inch square to create fringe. Be sure to leave approximately 1/4-inch at the base uncut. Glue the strip to the uncut side of the fringe approximately 1/4-inch from the edge.


Begin rolling with a quilling tool or a skewer at the base of the 1-3/4-inch square and ending at the end of the strip. Glue in place.


Glue the leaves onto a 1-inch paper scallop.


Glue the unit to the top of the box.


Make one or make more. I happen to think that a grouping of multi-patterned carrots look cute together.


The carrots were tucked into a paper basket along with some wispy paper shred. I'm sure that many of you will remember these woven paper baskets from your elementary school days. Embellish the basket with a cluster of pretty flowers for a fun Spring look.


Despite the lengthy instructions, this is super simple to create. Once I had the pattern configured, I was able to complete 8 carrots in about 45 minutes. I hope you give it a try!

Happy Easter, everyone!